Suction Cups/Clamps
- Clean and rinse all suction cups/clamps daily.
- Store suction cups on their sides (do not store them on their seals).
- Disconnect and reconnect the tubing at least once a week to exercise the fittings and clear out any debris in the fitting.
- Disconnect and cut ends of tubing every so often to remove worn-out/damaged ends for better sealing.
- Typically, top seals should be replaced every 6-18 months (depending on use).
- Typically, bottom seals should be replaced every 12-24 months (depending on use).
- Lubricate mechanical and pneumatic clamps parts as needed (We use and recommend Magnalube-G).
-
- Retractable Suction Cup with Air Switch bu Blick Industries
-
- 200 mm Radius Corner Suction Cup by Blick industries
-
- 150 x 240 mm Concave Corner Suction Cup (Right) by Blick Industries
-
- Vanity Sink Suction Cup Set by Blick Industries
-
- Vanity Sink Suction Cup Kit by Blick Industries
-
- 250 x 500 mm Low-Profile Suction Cup by Blick industries
-
- 200 x 200 mm Low-Profile Suction Cup by Blick industries
-
- 160 mm Round Suction Cup (Glass) by Blick Industries
-
- 250 mm Round Suction Cup by Blick Industries
-
- 40 x 150 x 300 mm Support Suction Cup by Blick Industries
-
- 150 x 500 mm Suction Cup by Blick Industries
-
- 200 x 200 mm Suction Cup by Blick Industries
-
- 250 x 500 mm Suction Cup by Blick Industries
-
- Suction Cup Starter Kit by Blick Industries
-
- Custom Hexagonal Fixture by BLICK INDUSTRIES
-
- Custom Trophy Fixture by BLICK INDUSTRIES
-
- Large Mechanical Vacuum Clamp by Blick Industries
-
- Pneumatic Swing Clamp by Blick Industries
-
- T-Nut and Bolt for slotted tables by BLICK INDUSTRIES
-
- Backsplash Clamp System by Blick Industries
Manifolds
- Exercise all valves/fittings daily.
- Thoroughly rinse and blow out manifolds/fittings weekly.
- Disconnect and cut ends of tubing every so often to remove worn-out/damaged ends for better sealing.
- Help prevent leaks in your vacuum system by replacing valves and fittings whenever needed.
NOTE: We carry a full line of fittings and replacement manifolds for all machines.
-
- Portable Manifold by BLICK INDUSTRIES
-
- BLICK INDUSTRIES Manifold Gauge Block
-
- 5-Port Venturi Manifold by BLICK INDUSTRIES
-
- Blick Industries Intermac Manifold – Right
-
- Single-Port Venturi Vacuum Generator by BLICK INDUSTRIES
-
- 25″ Universal Manifold (8 Pair) | Stone Glass Porcelain Wood Solid Surface
-
- BLICK INDUSTRIES Dual Vacuum Generator Kit
-
- Blowback Kit bu BLICK INDUSTRIES
-
- Blowback Kit bu BLICK INDUSTRIES
